Lift cables carry serious load alongside the springs. When one frays or snaps, we replace both cables as a pair and check the drums for wear.
A single-cable fix often means a second failure soon after. We explain the pair-replacement logic upfront.
Cable replacement without a drum check is an incomplete repair, so we always look at both.
Our technicians are trained to safely release and reset tension when cables are involved, not just the springs.
A same-day fix is standard for cable failures, parts already on the truck.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
We replace the snapped cable and its pair, then verify even tension across both sides.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
A door hanging crooked usually means one cable or spring has failed while the other holds. We correct both the immediate hazard and the root cause.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Cable stock on the truck means most calls avoid a second trip for parts.
We check both cables and the drums together, then quote a flat price covering the full fix.
We verify the door hangs and travels evenly before calling the repair complete.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Caught the fraying cable during a routine call before it actually snapped. Appreciated the heads-up.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
Both cables typically get replaced together to avoid a near-term repeat call.
Yes, a door hanging on a single cable or spring can drop unexpectedly and should not be operated until repaired.
We check the drum groove condition whenever a cable keeps coming off, since replacing just the cable won't fix a bad drum.
Pricing depends on cable length, gauge, and whether the drums also need replacing, confirmed as a flat number before work starts.
Most cable replacements are completed same-day, typically within one to two hours once the technician arrives.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Tea to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Tea, SD